Tips to solve floor problems
The simple fact of buying a beautiful new hardwood floor is something that people usually do. But the problem begins days later when you begin to witness the damage from moisture or floods. Fortunately, there are some useful tips if you suffer less deformation on your hardwood floors. However, if buckling is due to extreme exposure to moisture, you may have to consider replacing entire planks.
Buckling can occur for several reasons. Whether there is too much weight on the wooden floor or exposure to moisture, the first step in fixing it is to understand why buckling occurs.
What is buckling
Also called cupping or crowning, it is the most extreme case of too much exposure to moisture for hardwood floors. When a board has started to separate from the floor, it has begun to bend. Although most cases of too much moisture can be resolved before buckling occurs, it does.
Cupping is when the edges of a board begin to rise above the middle section. The coronation is when the middle section begins to swell above the edges.
Buckling, along with hollowing and crowning, is a relatively common occurrence, especially in homes with high moisture or moisture content. When you have your wood floor installed, make sure that the installer is certified by the National Wood Flooring Association and check the moisture content of the house before installation.
Finding the problem
Before considering a floor repair, you must find the problem. Again, if the problem is related to improper installation, you may run the risk of replacing the entire floor. However, if the cause is related to moisture, finding the source and fixing it could cure the buckling without having to replace anything.
To begin, you should contact your installer and ask him to take moisture readings of the house and the floor. Hardwood floors should always have a low moisture content. As the wood absorbs water naturally, it should always be kept as dry as possible.
Discovering the moisture content of the boards will tell you if the problem is related to the humidity of a faulty installation. If you can not find the source or if you decide to replace the wooden floor before locating the source, you have not solved the main problem. The simple replacement of the planks will only be a temporary solution if the source of moisture is not found and is not corrected.